Skip to main content

Hurakan

Home/Guides/Reach-In Refrigeration
Food Safety

Safe Refrigeration Temperatures

The numbers inspectors check — and how to hit them

Health inspectors carry a thermometer for a reason: temperature is the simplest, most important control in food safety. Here are the targets for every type of commercial refrigeration, why they matter, and how to measure and log them properly.

The Key Numbers

Based on the FDA Food Code — check your local health code
41°F
Cold holding

Refrigerated food that needs temperature control must be held at 41°F (5°C) or below.

41–135°F
Danger zone

The range where bacteria multiply fastest. Keep food out of it as much as possible.

0°F
Frozen storage

The common target for frozen food quality and storage life.

Notice the difference between air temperature and food temperature. The rule is about the food. Most operators set refrigerators to 36–38°F so that food stays safely below 41°F even when doors open often during service.

Targets by Equipment

And the ranges Hurakan units are built for
EquipmentTypical settingHurakan operating range
Reach-in refrigerator36–38°F33–40°F (C) · 33–41°F (E, ES)
Prep table36–38°F, lid closed when idle33–40°F (C) · 33–41°F (S)
Undercounter36–38°F33–40°F (C) · 33–41°F (S)
Bakery display case36–40°F33–40°F
Back bar coolerBeverages: to taste; food: 41°F or below33–40°F
Reach-in & undercounter freezer0°F or below−8 to 0°F (C, E) · −10 to 10°F (ES, S)

How to Measure

The display is not enough
  1. Use a calibrated probe thermometerCheck calibration regularly with ice water (it should read 32°F).
  2. Measure the food, not just the airProbe the center of a product, or keep a glass of water on a middle shelf and probe that.
  3. Check the warmest spotUsually near the door and on the top shelf. If it is safe there, it is safe everywhere.
  4. Compare with the displayIf the probe and the controller disagree by more than a couple of degrees, have the sensor checked.

Logging & Corrective Action

What a good log looks like

Opening

Record each unit’s temperature before prep starts.

Mid-shift

Record again at the busiest point — that is when doors open most.

Closing

Final reading; close prep table lids and check door seals.

Out of range?

Write down what you did: product moved, unit adjusted, service called. Then follow the not cooling checklist.

Cooling cooked food

Refrigerators are built to hold cold food. The Food Code requires cooked food to cool from 135°F to 70°F within 2 hours and to 41°F within a further 4 hours. Use shallow pans, ice baths or a blast chiller — never a full pot straight into a reach-in.

Frequently Asked Questions

Refrigeration temperatures
What temperature should a commercial refrigerator be?

Cold-held food must stay at 41°F or below. Most kitchens set refrigerators to 36–38°F to keep a safety margin.

What temperature should a commercial freezer be?

0°F or below is the common target for frozen food.

What is the temperature danger zone?

Under the FDA Food Code, the range between 41°F and 135°F, where bacteria grow fastest.

How often should refrigerator temperatures be logged?

Many operations log at opening, mid-shift and closing. Your local health department or food safety plan may set specific requirements.

Need refrigeration you can rely on?

Hurakan reach-ins, prep tables and undercounters use ventilated cooling.