Skip to main content

Hurakan

Home/Guides/Fryers
Troubleshooting

Commercial Deep Fryer Troubleshooting

Symptom → likely cause → first check

Most fryer problems in the middle of service come down to a handful of causes: gas supply, the pilot, the thermostat, or the oil itself. Use this guide to find the likely cause fast — and to know when to stop and call a technician.

Before You Touch Anything

Gas and hot oil are not DIY territory
Smell gas?

Turn off the fryer and the gas supply, do not use switches or flames, ventilate the area and call your gas utility or emergency services. Everything below assumes there is no gas smell.

The checks in this guide are things any trained cook or manager can look at safely. Repairs to gas valves, thermostats, thermocouples and burners must be done by a qualified technician, following the manual for your model.

Symptoms & First Checks

Start at the top of each row
SymptomLikely causesWhat to check first
Pilot will not lightGas supply off, air in the line after a shutdown, dirty pilot orificeIs the main gas valve open? Do other gas appliances work? Follow the lighting instructions on the unit.
Pilot lights, then goes outThermocouple not sensing the flame, draft blowing the pilot outLook for a strong draft from a fan or door. If it keeps going out, call a technician — the thermocouple may need replacement.
Burners will not come onThermostat set below oil temperature, pilot out, gas valve issueIs the pilot lit? Turn the thermostat up and listen for the burners to ignite.
Oil heats slowlyPartially lit burners, low gas pressure, overloaded baskets, old oilWatch the flames: they should burn along the whole burner. Fry smaller batches. Change tired oil.
Oil gets too hotThermostat or control faultTurn the fryer off immediately. Do not use it until a technician has checked it.
Oil foams or boils overWater in the oil, worn-out oil, overfilled vat, wet foodDrain and replace old oil, dry the tank after cleaning, shake ice off frozen food, keep oil at the fill line.
Yellow, smoky flamesBurner or air shutter needs adjustment, dirty burnersCall a technician for burner adjustment and cleaning.

When the Problem Is the Food

The fryer may be fine — the oil is not
Greasy, soggy foodThe oil is too cool, or the basket was overloaded so the temperature dropped too far.
FixLet the fryer recover to setpoint between batches and fry smaller loads. Fast recovery is why burner power matters — see fryer sizes.
Dark outside, raw insideOil is too hot for that product, or the oil is old and darkens food faster.
FixLower the setting a little for thick items, and check oil quality.
Bitter or off tasteOil is broken down, or flavors are carrying over from fish or seasoned products.
FixChange the oil and use a separate fryer for fish. Read when to change fryer oil.
Lots of smokeOil is past its smoke point — too hot or too old.
FixCheck the setting, filter or replace the oil, and clean the vat with a boil-out.

Stop and Call a Technician When…

Not a job for the line
  • You smell gas, or hear hissing near the valve or connector.
  • The oil keeps heating past the thermostat setting.
  • The pilot will not stay lit after you have checked supply and drafts.
  • Flames are yellow, uneven or roll out of the burner area.
  • You see damage to the gas connector, valve or controls.

Hurakan owners can request service on our Service & Support page. Hurakan fryers include a 1-year U.S. warranty on parts and labor.

Frequently Asked Questions

Fryer problems
Why won’t my commercial fryer pilot stay lit?

The most common reason is a thermocouple that no longer senses the pilot flame, or a draft blowing the flame out. Check for drafts first; if it still goes out, call a qualified technician.

Why is my fryer oil foaming?

Foaming usually means water in the oil, oil that is worn out, or an overfilled vat. Replace the oil, dry the tank thoroughly and shake ice off frozen product.

Why does my fryer take so long to heat up?

Check that all burners light along their full length. Low gas pressure, overloaded baskets and old oil also slow heating and recovery.

What should I do if the fryer overheats?

Turn it off immediately and do not use it until a technician has inspected the thermostat and gas controls.

Replacing an old fryer?

Hurakan gas floor fryers come in 40, 50 and 70 lb classes, for natural gas or LPG.