Skip to main content

Hurakan

Home/Guides/Fryers
How-To

How to Clean a Commercial Deep Fryer

Daily, weekly and monthly — step by step

A clean fryer makes crispier food, uses less oil and lasts years longer. A dirty one makes bitter, dark food, foams over and becomes a fire risk. This is the routine professional kitchens follow, broken into simple steps.

Safety First

Read this before you drain a drop
Three rules that prevent burns

1. Never add water to hot oil — it flashes to steam and throws oil out of the vat. 2. Let oil cool to a safe temperature before draining or filtering, and wear heat-resistant gloves and an apron. 3. Turn the gas valve off before cleaning, and never leave a boil-out unattended.

Every Day: Skim & Filter

15 minutes that double oil life
  1. Skim during serviceRemove floating crumbs and batter bits with a skimmer every few batches. Burnt particles break oil down fast.
  2. Let the oil cool after closingTurn the fryer off and wait until the oil is warm, not hot, before filtering.
  3. Filter the oilDrain through a filter cone or a filter machine into a suitable container, then return clean oil to the vat.
  4. Wipe the fryer and basketsWipe the top, sides and the area around the vat. Wash baskets in hot soapy water and let them dry completely.
  5. Cover the vatA cover overnight keeps dust and moisture out of the oil.

Every Week: The Boil-Out

Or at every oil change

Filtering removes crumbs, but a sticky, darkened film still builds up on the walls of the tank. A boil-out dissolves it. Do it weekly, or every time you change the oil — high-volume kitchens often boil out more often.

  1. Drain completelyWith the fryer off and the oil cooled, drain all oil and dispose of it according to local rules.
  2. Remove sedimentScrape crumbs and sludge from the tank bottom and around the burner tubes.
  3. Fill with water and cleanerClose the drain valve, fill with water to the oil fill line and add a fryer boil-out cleaner following its label.
  4. Heat gentlyBring the solution to a gentle simmer, then turn the heat off. Never let it boil hard or leave it unattended.
  5. ScrubUse a long-handled fryer brush on the walls and corners. Do not use steel wool, which leaves particles behind.
  6. Drain, rinse, neutralizeDrain the solution, rinse with clean water, and rinse again with a little vinegar if the cleaner’s label recommends it.
  7. Dry completelyWipe the tank dry and leave it open to air. Any water left in the vat will spatter violently when oil goes in.
  8. RefillClose the drain valve and refill with fresh oil to the fill line.

Every Month: Look Underneath

The parts nobody sees

Roll it out

Hurakan FXF50EW, FXF50W and FXF70W stand on locking casters, so you can roll the fryer out and degrease the floor and wall behind it. Disconnect the gas only as your installer showed you.

Check the pilot and burners

The pilot flame should be steady and blue, and burners should light evenly along their length. Yellow, lazy flames need a technician.

Clean the cabinet

Wipe the inside of the door and cabinet, where oil mist settles and attracts dust.

Check the hood filters

Greasy filters above the fryer are a fire hazard. Clean them on the schedule your hood service sets.

Cleaning Checklist

Print it and tape it near the fryer
  • Daily — skim during service
  • Daily — filter oil after closing
  • Daily — wash baskets, wipe exterior
  • Daily — cover the vat overnight
  • Weekly — full drain and boil-out
  • Weekly — tank dried completely before refill
  • Monthly — clean behind and under the fryer
  • Monthly — check pilot and burner flames

Oil going dark too fast even with good cleaning? Read when to change fryer oil. Fryer not heating properly? See fryer troubleshooting.

Frequently Asked Questions

Fryer cleaning
How often should you boil out a commercial fryer?

At least once a week, or every time you change the oil. Busy kitchens that fry all day often do it more often.

Can I use dish soap to clean a fryer tank?

Use a cleaner made for fryer boil-outs and follow its label. Whatever you use, rinse thoroughly and dry the tank completely before adding oil.

Should I filter fryer oil hot or cold?

Filter it warm, not hot. Oil flows better when warm, but hot oil causes serious burns. Follow the manual for your filter equipment.

What happens if water gets into the fryer?

Water sinks under the oil and turns to steam when heated, throwing hot oil out of the vat. Always dry the tank, baskets and food as much as possible.

Time for a new fryer?

Compare 40, 50 and 70 lb models in our fryer buying guide, or ask us for a recommendation.